FEINTOOL FB ONE 11000

•  
  參考 50429

  制造年度 2023

  运行小时数 不适用

• 供应商

  ProdEq Trading GmbH
  Reckholder 1
  9527 Niederhelfenschwil

  Switzerland

  

• 主要类别

  金属加工机床

• 类别

  液压驱动压力机

• 机器类型

  精冲压力机

• 制造商

  FEINTOOL

• 描述

  CONTROLS
    PC controller BECKHOFF
  
  PRESS DESIGN
    drive system: servohydraulic
    frame design: H-frame, tie rod
    quick die change system: yes
    feedstock transport direction: left to right
  
  SLIDE
    total force (nominal): 1100 to
    stroke: 130 mm
    stroke rate (max.): 60 /min
  
  COUNTER RAM
    nominal force: 330 to
    stroke: 40 mm
  
  V-RING
    nominal force: 500 to
    stroke: 40 mm
  
  TOOL DIMENSIONS
    lower table (left-right): 960 mm
    lower table (front-back): 960 mm
    upper table (left-right): 960 mm
    upper table (front-back): 960 mm
    shut height max.: 470 mm
  
  OVERALL SPECIFICATIONS (COIL LINES)
    sheet width max.: 500 mm
    sheet thickness max.: 16 mm
    coil weight max.: 8 to
    feedstock transport direction: left to right
  
  COIL CHAIR
    coil weight max.: 8 to
    stroke: 700 mm
  
  DECOILER
    coil weight max.: 8 to
    max. diameter of coil: 1800 mm
    mandrel expansion range from: 470 mm
    mandrel expansion range up to: 530 mm
  
  LEVELLER UNIT
    sheet width max.: 500 mm
    sheet width (min): 80 mm
    sheet thickness max.: 16 mm
    sheet thickness min.: 1.5 mm
    material cross section max. (450 N/mm2): 3510 mm²
    number of leveller rolls: 17
    integrated feed function: yes
    intermediate clamp release: yes
    cleaning device for leveller rollers: yes
  
  CROP SHEAR
    cutting force: 800 kN
  
  ELECTRICAL SPECIFICATIONS
    mains power supply: 350 kVA
    mains voltage: 400 V
    mains frequency: 50 Hz
  
  DIMENSIONS / WEIGHTS
    total weight approx.: 75350 kg
  
  
  Absolutely mint condition: just 3'300 running hours, 700'000 strokes
  
  Special equipment fineblanking press: + block hydraulics for 4th and 5th force. High pressure 30-270 bar. + mechanical reamers (without tool-bound sliders) + additional operating mode "cutting without counter-holder and V-ring" + additional operating mode "manual insert mode" + 2 blast air circuits with 6 connections each + Additional tool monitoring + RAZIOL roller belt lubrication system with 2 reservoirs + Interface for monitoring the cooling system
  - the scrap conveyor (visible on photos) is not part of the scope ARKU single reel with loading chair: + 2 pressure arms for high-strength coil material + Coil guidance via conical rollers + Automatic coil centre positioning ARKU feed straightening machine: max. straightening cross-section at 600 N/mm2: 3510 mm2 + Synchronised drive of the straightening rollers + Hardened and ground straightening rollers + Servo-hydraulic leveller gap control + Straightening roller quick-change system + intermediate roller release + Measuring wheel for feed control
  

• 国家

  二手